| John Deere Tractors Discussion Forum |
Topic: 630 Clutch Bearing Washer F1395R
[Return to Forum]
| Author |
[Modern View]
|
| GlenT
10-04-2012 15:26:11
71.210.174.150
|
The JD parts catalog page 20-8 shows F1395R key 16, bearing washer, facing so that the bent in part hits the inner race of the bearing. The bent in part is 1/8 inch looking at the JD parts breakdown online. I Probably shouldn't question the parts Bible (catalog) but if the bearing washer was turned around, it would clear just fine, hold more grease for the bearing, and show a profile to the bearing as the Bearing Retainer, key 13, F1394R does. Any thoughts on which way the bearing washer should go?
Thanks
|
|
|
|
| wijim
10-04-2012 16:26:14
166.182.3.104
|
|
Re: 630 Clutch Bearing Washer F1395R in reply to GlenT, 10-04-2012 15:26:11
|
|
| I just went through that delema, so I went against the pic in the book and put it in away from bearing.
|
|
|
| GlenT
10-05-2012 07:18:58
71.210.174.150
|
|
Re: 630 Clutch Bearing Washer F1395R in reply to wijim, 10-04-2012 16:26:14
|
|
| Thanks for the speedy reply. It makes sense to put it in the way you did.
|
|
|
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
