Update on 566 Baler

Lazy WP · Jun 19, 2017

Today I had a few minutes, and was messing with the monitor in diagnostic mode. In channel 10, I have an audible alarm and a reading of 12. Book says it should be zero. I think 10 is the net knife sensor? I don't have net wrap, so what do I have wrong?

Tx Jim · Jun 20, 2017

I think if your baler doesn't have option of netwrap you should disregard results of channel 10 for test of netwrap switch

Lazy WP · Jun 20, 2017

Would it still make the stop light come on?

Tx Jim · Jun 20, 2017

I think absence of netwrap switch will not affect operation of stop switch on twine only baler. Have you performed test shown below?

calfeeder · Jun 21, 2017

IF YOU GET A 12 0N CHANNEL 10, MONITOR IS HUNTING FOR NET WRAP AND IT IS NOT ON BALER. GO TO CHANNEL 10 AND HIT MINUS BUTTON TO GET A ZERO. THIS SHOULD HELP YOU

Update on 566 Baler

Lazy WP

Well-known Member

Tx Jim

Well-known Member

Lazy WP

Well-known Member

Tx Jim

Well-known Member

calfeeder

Member

Similar threads