(quoted from post at 09:44:00 03/27/17) My Sears saw is the tilting table model, not a sliding table model. The blade guard is a loop of flat steel of about 1/4" by 2" over top of blade and about 2" to side of blade (just guessing at these measurements without going out to barn to measure, saw has not been used in 20 years), Dad did not like that much clearance between blade and guard so small pieces could not get caught so he put wood fillers in there to give about a half inch blade clearance. Not sure if in all the paperwork I have a sliding table model is shown or not.
(quoted from post at 11:38:50 03/27/17) Best shot I have of how the guard mounts hope it helps. Their
isn't much holding it on
Untitled URL Link
(quoted from post at 12:15:29 05/09/17)
I do not but there is a photo link on the first page that shows some of it
(quoted from post at 15:43:19 11/18/20)(quoted from post at 12:15:29 05/09/17)
I do not but there is a photo link on the first page that shows some of it
Hello
Does anyone know how to remove the blade collars?
I have soaked it in Pb Blaster for a week but cannot get it to budge?
Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy