Sauder Plow Receiver Bracket

I recently pick up a Sauder dozer blade that I would like to use for snow plowing with my Ferguson TO20. Unfortunately, the person I bought the plow from did not have the bracket that bolts under the rear axle. I found this picture on the site and was wondering if anyone has dimensions of this bracket so I could got one fabricated?

Thanks!
 
I don't currently have one off a sauder but you might want consider making something similar to the one in the photo. I know this is for a two pipe system but using a single middle pipe might work. Just to give you some ideas. I know a guy who has one on his ford 600 and I don't know why but he won't sell it and he doesn't have a snowplow for it.

Kirk
snowplow%20frame%20bracket_zpso3b8imee.jpg
 
Hi Kirk,

Thanks for the picture. The Sauder system has a single point going to the rear bracket. Would you be able to ask the guy with the Ford 600 that has the receiver to see if he would like to sell it?

Thanks!
 
I will ask him and let you know
What would you offer for the piece? They are kind of a pain to box and ship cause of the lever that sticks up
 
Don't really know what kind of price to ask. Maybe see what he would want for it and go form there? I'm in Delaware so maybe I could pick the piece up depending on what area of New Jersey you are located.

Thanks!
 
I asked and he doesn't want to sell it.
Here is a photo of one. This one is not like the originals I have seen with the long lever. Might even be homemade but at least will give you some ideas to make one.
Sauder were built in Pa near lancaster so maybe put an add on craiglist in the farm and garden section. The tractor gets sold with them on and the plows got scrapped

Good luck

Kirk
Rear_mounting_bracket_for_Sauder_loader_bottom_view_off_tractor_zps4mob7rha.jpg
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top