(800) 853-2651
SHOP NOW

Allis Chalmers #2 plow

L

Lyle Knight

Member
Had a real nice 2 bottom Allis #2 plow on steel wheels given to me. Having trouble with the ground trip! It trips down just fine, but when I try to trip it up, the ground wheel slides and jumps for quite a distance before it will finish the trip and lock. Is there something that needs adjusting?
 
First question is do you have the knobs (luggs) on the lift wheel? It needs something to grip with. After that clean and lube.
 
Yes it does have knobs on wheels. I was tripping it with the levers set so the plow would not enter the ground as I was just trying to loosen everything up. If I actually plow will that make a difference?
 
Was the plow plowing a good loking furrow?

Where do you have the levers set? Low, Midway< all the way up the notches?

Check the spring on the trip lever. If it is too weak, the plow will kick itself out of lock OR engage and hop in and out, up and down. The spring must be loose enough that you can easily pull it, but tight enough that it holds the plow int whichever setting you have it in.
 
Pull the clutch apart and clean the crap out of it. There in not anything you can't deal with inside. Grease it good when your done. Every one I have taken apart the old grease and dirt was hard in areas that had to be chipped out with a screwdriver. I had to put a large washer behind the hub on one. After it is clean you can tell if the hub slides on farther than it should. Some take up on the front under the cap.
 
Put the levers 2/3s the way up and see what it does.
I wouldn't think that the levers being down would negitivly effect the operation of the plow.
DID YOU look at the trip lever while operating the plow to see that it stayed in either locked in or out while moving?
 
You must log in or register to reply here.

Similar threads

F
Allis Chalmers 9000 plow
Replies
3
Views
394
fastfarmall
F
W
Allis Chalmers 3 bottom Roll-Over Plow
Replies
5
Views
336
Skyhighballoon(MO)
Skyhighballoon(MO)
M
Allis Chalmers 5050 - a good tractor??
Replies
9
Views
648
MF in Canada
M
O
Allis Chalmers 621 Rough terrain forklift opinions
Replies
4
Views
284
oldfarmall
O
K
wc plowing
Replies
4
Views
415
Texas Denny
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top