Deutz Fahr RB 3.20 OC

jd1

New User
I have been reading YT for several years and find it intersting and educational.
Hope someone can help with my friends Deutz Fahr round baler.
Baler makes good bales but when he puts net wrap on the net wrap does not
get cut and get pulled along when bale is dumped. He has to go cut net wrap
with knife after each bale. Also net wrap does not spread fully across bale it
always goes in about 19 inches on each side.He has the manual and adjustments
see ok. How can we repair this? Thanks Al.
 
Not sure why it's not going on full width. Seems strange that it is doing the same thing on both sides... are there stops inside to keep the twine from getting to close to the edge of the bale??

As for the net wrap not cutting, the first thing I'd check is the tension on the wrap, my claas doesn't cut properly if the wrap is a little loose. Never seen a deutz in person, so not sure if this will help or not.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top