(800) 853-2651
SHOP NOW

New Holland 355 Grinder-Mixer parts

W

wwcfarm

New User
Hello all,
Writing from a small abundant arts college in North Carolina with a 300 acre farm growing hogs, beef, poultry, lamb, and small grains.
We use a New Holland 355 Grinder-Mixer and I'm on the hunt for a part that is no longer manufactured.
We are looking for the clamp/collar and handle that locks the unloading auger into place when you swivel it out to bag feed or fill a bin.The handle is part #714848 I believe and I haven't found the clamp/collar clearly in the diagram.
I've been searching online and calling around, but I figured it can't hurt to check in as many places as possible. Anyone have a scrap one hanging around?
Many thanks
 
I can't tell you where to find the part,but I can tell you how to remedy the situation if you just want to keep it from swinging. The guy who had this one before me welded a short piece of small pipe,vertically to the lower right side of the ladder and put this rod on it. It lays up in the winch when not in use,then is bent on the end to drop in to the pipe. I made one improvement to it. I drilled a small hole in the rod so I can put a small hair pin through it to keep it from jumping out of the pipe when I'm moving from one creep feeder to another.
a211595.jpg
 
You must log in or register to reply here.

Similar threads

D
New Holland 352 Grinder Mixer
Replies
2
Views
686
caterpillar guy
C
Z
New Holland 350 mixer grinder unloading auger
Replies
6
Views
979
Z71caleb
Z
G
gehl 55 vs new holland 355 grinder mixer
Replies
11
Views
5K
olgentdc
olgentdc
G
New Holland 355 grinder/mixer
Replies
3
Views
380
Bradiniowa
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top