New Idea Cut/Ditioner 272 knives

Can anyone provide a source and part number for the cutting knives on a New Idea Cut/Ditioner model 272? I've Googled all I can think of and haven't found it.

I'm trying to determine how far worn down the knives are on the unit I have, because it won't cut lower than about 5 inches and I've been told these machines should go down to just about scalping the ground.

Thanks.
 
The manual I have gives a part number but not a length for the knives. NI part number is 270180. We had to go through a NI dealer. This is an old number and probably been updated. Might want to check your height adjustment or if the lift is binding up. The position on the front roll also makes a difference as well as the wheels and tires.
I strongly recommend getting an operators manual. AGCO should have it. Good luck!
 
Hi, see the photo with red line. When the knife gets worn to about the red line, it is time to replace the knife.
a201203.jpg
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top