Absent Minded Farmer
Well-known Member
- Location
- Gehl Country, Wis.
Hey guys, I managed to break the bearing off of the top of the square tube that sticks out the back of the plunger. Sheared it clean off of the stud or pin or whatever you want to call it. Is this going to require a complete plunger replacement or is there a kit to replace the "tail" with the bearings on it? Also, did NH have service manuals for these balers? All I can find is owners & parts manuals. I'd like to go over the rest of the machine to see what damage has been done due to the bearing failure & perhaps enact some preventative maintenance.
Thanks,
Mike
Thanks,
Mike