IH Mower

homer long · Jun 19, 2015

I just got this old mower and I think its an ih model 32 trail mower need lenght of wooden pitman arm and points measured from some sketches would really be helpfull Thanks for any replies Homer

JRSutton · Jun 19, 2015

I don't know the answer to your question, but it's fairly easy to figure out very accurately if you don't get an answer.

You want the knife bar "in register" (the sections centered on the rock guards at the beginning and ending of every stroke).

Put the knife bar at the far end of its stroke, center the sections perfectly on the rock guards there. Then just rotate the crank wheel to it's outermost position (as if the pitman where attached, pushing the knife bar).

Then it's easy - just measure the hole to hole distance for the mounting bolts (the most important measurement). Then just make a close estimate on total length, that's less important.

IH Mower

homer long

Member

JRSutton

Well-known Member

Similar threads