steven in Tn
Member
building a 3pt hay unroller that pulls the hay on the ground to unroll and have couple questions.
1. do the spears need to turn with a disc with ears on it to grab into the side of the bale or can i just weld spear to the end of the arms and let the bale roll on the spears.
2.and where the bale arms meet the main frame of the unroller would it be better to weld the brackets onto the frame or onto the arms? i have seen them both ways but not sure which would be strong or if it matters?
and if anyone has any measurements of one that would be helpful but i think i can figure it out by measuring my hay and building it to what i think it needs.
1. do the spears need to turn with a disc with ears on it to grab into the side of the bale or can i just weld spear to the end of the arms and let the bale roll on the spears.
2.and where the bale arms meet the main frame of the unroller would it be better to weld the brackets onto the frame or onto the arms? i have seen them both ways but not sure which would be strong or if it matters?
and if anyone has any measurements of one that would be helpful but i think i can figure it out by measuring my hay and building it to what i think it needs.