I found some very good old posts on this site that are too old to reply to, so have to start a new thread.
I have a 385 JD Baler w/ the silage kit that keeps shearing the shear bolt when trying to bale silage. I read a post about putting on a pressure adjusting valve and gauges. Would anyone have more information?
Also, I got a bit fooled when I bought the baler, the previous owner had taken out the CV joint. I just checked; JD price for joint alone is just under $1000, replacing the whole front driveshaft half is $1400. Any other good driveshaft sources?
Thanks
I have a 385 JD Baler w/ the silage kit that keeps shearing the shear bolt when trying to bale silage. I read a post about putting on a pressure adjusting valve and gauges. Would anyone have more information?
Also, I got a bit fooled when I bought the baler, the previous owner had taken out the CV joint. I just checked; JD price for joint alone is just under $1000, replacing the whole front driveshaft half is $1400. Any other good driveshaft sources?
Thanks