I am furious about trying my darnedest to get the baler timed now after breaking the knotter drive shear pin. Read the book and read the book. Plunger head in CENTER of front hay tooth opening. Set hay teeth to 15-1/4". Unhooked MAIN drive drain to get hay teeth set at 16-1/4. Trip knotters and it wants to hit the plunger stop !!!! What am I doing WRONG ???? You can call me (308)-763-1265 to beat this into my head for a better understanding. Acts like its 180* off. Thanks . I am reading the OP manual too.
- Thread starter Husker44A
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy