Re: winpower pto generator problem in reply to IaGary, 01-27-2013 16:55:28
Sure did. Tried my grinder. Just hummed a little. The gague on the generator didn't read much either. Is it possible this runs on 1000 even though it says 540 on it? It didn't have a shaft on it so I through on a 540 assuming that was it.
Re: winpower pto generator problem in reply to nick m, 01-27-2013 17:02:21
Did you over speed it a little to see if that made a difference? I would hope that if it is 1000 RPM it would have a fine splined shaft on it. My 540 PRM unit has the standard 6 spline shaft. I believe the armature turns 1800 regardless.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.