(800) 853-2651
SHOP NOW

Ac snap coupler plows

F

forddoc

Member
Can a three bottom snap coupler plow be converted into a two
bottom and pull right or not? Picked up a wd45 but it don't
have enough left in the tank to pull the 3-16, so I wondered
about dropping a bottom. But I'm not familiar with how an ac
two bottom compares to a three bottom, and don't want to
mess up how it plows.
 
Yes, and no is the answer. The convertible plows, you can do it by dropping the frame pieces and the standard, off of the left most bottom, IIRR. If the frame as 2 sets of holes, you can convert it from 3-14, to 2-16, if you can find the 16" bottoms.
 
Yes. Drop the back and middle bottoms and then put the back one back on. Did it a couple of times with my 3-14". I never adjusted the draft point or anything and they pulled just fine as a 2 or 3 bottom.
AaronSEIA
 
Forddoc,
I have a snap coupler 2 bottom I would like to trade for a 3 bottom. Hopefully, your close. My email is open.
 

A WD-45 should have no problem with a mounted 3-16" plow..unless it needs weight and better tires.

Gosh, a WD came standard with a 3-14"...!!

3-16" should not pull all that much harder than 3-14" and quite a bit easier than 4-14" (which I use)..

Ron..
 
You must log in or register to reply here.

Similar threads

C
Adjusting an A193 plow
Replies
12
Views
456
BarnyardEngineering
BarnyardEngineering
B
IH Fast Hitch Plow and Disc ID
Replies
7
Views
762
Kevin Happke
K
Scott 730
Cleaning bio diesel goo
Replies
7
Views
272
Butch(OH)
Butch(OH)
D
3-16 and 3-14 plows available in Western Iowa
Replies
0
Views
306
Duane Kaufman
D
T
Allis CA - Pin hitch or Snap coupler??
Replies
12
Views
11K
Ted J
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top