Author	[Modern View]
LenND 12-05-2012 17:42:33 74.207.160.118 Report to Moderator	The slide hammer I mentioned is the same thing as you mentioned. I have used it several times for that. The only problem is you need the end small enough to match the screw head. I ground the hammer head down to fit the screw. [Reply]   [No Email]
old 12-05-2012 17:48:16 209.86.226.57 Report to Moderator	Re: Advice on rusty slotted head screw removal on a 14 T baler in reply to LenND, 12-05-2012 17:42:33   Never seen or heard of any type of slide hammer type thing like you say. What I am talking about is maybe 6 inches long and you can change the tips so you can use a socket or a screwdriver tip and you hold it in one hand then hit it with a hammer and the action of the hammer makes the thing twist and also due to the hit forces it down so it hold better then a normal screwdriver would [Reply]  [No Email]
JRSutton 12-05-2012 18:51:27 75.130.109.233 Report to Moderator	Re: Advice on rusty slotted head screw removal on a 14 T baler in reply to old, 12-05-2012 17:48:16   an impact screwdriver - you put it in the slot and smack it with a hammer. A must have tool. Doesn't do you much good if the slot's already totally gone - but it would have avoided that problem had you tried it earlier. Looks like this [Reply]  [No Email]
Tim(nj) 12-05-2012 18:13:21 67.237.1.234 Report to Moderator	Re: Advice on rusty slotted head screw removal on a 14 T baler in reply to old, 12-05-2012 17:48:16   I have one of those. My father, a retired mechanic/machinist, calls it an 'impact driver.' Not to be confused with an 'impact wrench'. [Reply]  [No Email]