Wish at times I had one of the 3 I have set up. Have one that appears to have insert teeth in it but is only about 18 inches in diameter. Also have one with a 36 inch blade but just a normal tooth set up and some are rusted real bad. Then the 3rd has no blade but has the best feed set up. I can not run a gas chain saw any more but sure could do the buzz saw and an electric chain saw
Re: Anybody getting their buzz saws sharpened and ready in reply to Brad Buchanan, 10-25-2012 09:36:18
Have not rode the bike in over a year. Did ride the boys bike right after he got it to have it inspected and licensed but that was almost a year ago. My bike has been sitting now for over a year and only run a couple times in that time. I want to get or build a 3 wheeler but seems the $$ just aren't there for that at this time
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.