Dreaming Green IN
Member
I have a John Deere 350 sickle bar mower. Recently I got an old "dog bone" tool to repair the rivets in the knife.
Not sure I'm using it correctly. After aligning the tool's bottom mandrel to a rivet head, am I suppose to tighten the outer shaft against the knife, then crank down on the inner shaft to do the business of punching or peening?
Not sure I'm using it correctly. After aligning the tool's bottom mandrel to a rivet head, am I suppose to tighten the outer shaft against the knife, then crank down on the inner shaft to do the business of punching or peening?