Re: Hay Crimper
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
Not that it really matters, but wasn't the NH 404 considered a "crusher" and not a crimper. If I remember correctly (and I may not because I'm talking around 1966-69) it had a smooth steel upper roller and a rubber lower roller with spiral grooves running across the length of the roller. The New Ideas of the day were crushers with steel rollers that meshed with each other and actually crimped the hay.
The 404 was a great improvement over just cutting with a sickle bar and letting it lay until dry enough to rake and bale, but it had to be adjusted just right to prevent wrapping the hay around the rollers and plugging up, Whereas the New Ideas our neighbors had and we borrowed a few times before we had the 404 were great with no problems plugging. (As far as I remember any way) :)
P.S. Like show crop above stated, I remember spending a lot of time under that 404 with a jack knife too.
This post was edited by LaVern Skarzenski at 19:20:02 09/12/12.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters