Author	[Modern View]
JD Gimpl 08-01-2012 22:23:18 174.253.202.102 Report to Moderator	Hi folks. Has anyone seen or done a wood floor in a model H spreader. Was just wondering if this would work. Thx. Gimpl [Reply]   [No Email]
Tx Jim 08-04-2012 04:07:15 67.142.163.26 Report to Moderator	Re: JD Model H Spreader Wood Floor?? in reply to stephs oliver, 08-01-2012 22:23:18   TG The spreader that JD Gimpl intends to put a wood floor in can from the factory with a thinner metal floor so I think wood floor supports would need to be lower than the metal floor supports, [Reply]  [No Email]
rustyfarmall 08-04-2012 04:58:15 67.55.162.174 Report to Moderator	Re: JD Model H Spreader Wood Floor?? in reply to Tx Jim, 08-04-2012 04:07:15   Quoting Removed, click Modern View to see Yes, the JD model H spreader had an all steel floor. [Reply]  [No Email]
tg in VA 08-03-2012 16:56:45 75.210.60.146 Report to Moderator	Re: JD Model H Spreader Wood Floor?? in reply to JD Gimpl, 08-01-2012 22:23:18   Angle the leading edges of the boards. I replaced boards on a spreader and just cut the most severe angle the skill saw would cut to keep the apron bars from binding. The boards can be square at the rear. [Reply]  [No Email]
Tx Jim 08-02-2012 05:17:16 67.142.163.25 Report to Moderator	Re: JD Model H Spreader Wood Floor?? in reply to Hogleg, 08-01-2012 22:23:18   If you don't get the wood low enough the drag chain will catch on the wood floor at the frt of spreader. [Reply]  [No Email]