Threshing machine parts

sam in mo · Feb 19, 2012

Someone on here was needing a pully for a threshing machine earlyer this week.I might have the pully you need. I dont remember the size you needed but I have some that are about 2 and a half inches across about ten or twelve inches in diameter. I didnt have a ruler so these are just guesses. There is several pullys on this old machine.It was wood and has rotted down to the ground. Let me know if you still need parts or the whole machine.The spokes in the pulleys are also in a (S) pattern.

Nathaniel Watts · Feb 19, 2012

Thanks for the reply. Heres a pic of what I need. It has 255 cast in it.

Nathaniel Watts · Feb 20, 2012

Sorry, I forgot the measurements! Its just under 15" diameter, 3.5" or so wide. What kind of machine do you have, there is quite a bit of stuff I will need if yours is the same.

sam in mo · Feb 20, 2012

I dont know what make the machine is. I will have to go over to where it is at to measure the pullys.I think everything is there but the wood.I dont know where you are but the machine is about a hour west of st louis Mo. on I44.

combinechris · Feb 20, 2012

looks like it could be a yellow kid

Nathaniel Watts · Feb 20, 2012

Its a Frick Waynesboro Eclipse. If you look at the pic, the cast part to the left that is around the cylinder has Frick and Eclipse cast into it on one side of the other. I am in NC so me just coming out is not that easy! But if you have what I need I would be happy to pay you for your time!

sam in mo · Feb 21, 2012

Send me an e mail and I will give you the phone number of the man that has the thresher. I just got off of the phone with him and he wants to sell the whole machine or just the parts you want. He said he is going to scrap out what you dont take.

Threshing machine parts

sam in mo

Member

Nathaniel Watts

Member

Nathaniel Watts

Member

sam in mo

Member

combinechris

Member

Nathaniel Watts

Member

sam in mo

Member

Similar threads