(800) 853-2651
SHOP NOW

220 Spra-Coupe part needed...

I

IHMANKY

Member
It's an '86 model, so I figure it gets close to making the YT cut.. Agco wants a pot of gold for a new boom swing electric actuator, I'd rather buy a decent used one off of someone and pay them shipping as opposed to giving my firstborn to Agco. If you have one laying around or on a blown up machine and would like to sell one, I'd appreciate it.
 
If it has a hydraulic pump on it for anything, you could put a hyd. cylinder in place of the electric motor. I did that with a hesston round baler that the electric motor for the twine tie went out on. Worked as good as the motor did.
 
Gary, looked at those, looks like the same ones I found on Surplus Center's site, can't see a way to use them without some extremely creative fab work. I wish it did have a hyd. pump, we wouldn't be having this conversation! I'd convert it all to hyd. booms and be done with it! Much faster and more reliable. If I ever find a worthless coupe cheap that has the hydraulic portion intact, I will buy it and swap the hyd's over to mine. The commercially available kit is just too expensive to justify for me.
 
There used to be several around me here in North-East Iowa. When the electric actuators would go bad we would change them over to hydraulics. We would mount a Chrysler power steering pump and a valve stack. Then just bought new cylinders that would replace the electric actuators. Even back then the conversion was usually not much more costly than the new electric actuators.
The guys running them liked the hydraulics much better than the electric controls. They would work faster. Plus you could feather them too.
 
Haven't been by there in a while, but these guys usta have a bunch of used/salvage Spra Coupes out back and the head mechanic used to be the shop foreman when his dad owned the local A-C/Agco dealership: Bargain Equipment, Ripley, TN (731) 221-1002
 
You must log in or register to reply here.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top