I have seen a few pictures of the TransMix mixer and I have a couple of questions. Does anyone have a photo of the pto driving part that turns the mixer. And how is the outside frame attached to the rear axle. Does it attach on the stablizer pin or by some other bracket. I have been searching for one of these mixers to go on my 2N Ford but have not had any luck yet. Thanks for any info
Re: TransMix Concrete Mixer in reply to TonyS, 02-23-2007 19:06:25
Connection to rear axle:
I hope this helps. I have an entire series of photos showing the step-by-step installation of a TransMix on my Ford 850. Same procedure would basically apply to a 2N. The link below takes you to the entire page of thumbnails. Go to the very last photo then click "previous" or "back" to see them in the proper order. I also have a Word document containing all the photo captions. If the photos don't explain things adequately, send me an email and I will forward the photo captions, too.
Re: TransMix Concrete Mixer in reply to Jim.UT, 02-24-2007 14:08:31
Thank you Jim, I couldn't ask for a better set of photos. I have a much better understanding of how the mixer mounts and works, so when I do find one I'll know how complete it is or not. Thanks again. Tony
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.