(800) 853-2651
SHOP NOW

1680 IH COMBINE can't kill engine

A

anbdiesel

Member
Just put a remain 8.3 cummins in a 1680. farmer friend of mine
that ownes the machine pulled the engine him self and took
pump to the pump shop I swapped all parts over and put new
engine in it runs great but when you pull the throttle back to
the stop position it doesn"t die the pump does have a kill lever
on the back side and if you pull it it does die. My question is
am I missing a bracket or linkage or do I just need to adjust the
idle down low enuff to kill it?

Thanks in advance for the help !
 
If it was shutdown originally with the throttle lever just back out the top governor cover screw until it will stop with the throttle again. Takes a 13MM wrench and screwdriver. Some applications had a stop lever but never used it.
 
My 1660 shuts off with the throttle lever. So before you get into the pump, see if you can shut it off just by moving the throttle control farther.
 
The larger screw above the four bolt plate is the bumper spring assembly, used to help take out surge trouble. It should be OK where it is on a combine engine.
 
You must log in or register to reply here.

Similar threads

F
Cold starting MF 860 then no move
Replies
5
Views
470
fdt860
F
D
B Allis Only runs at low RPM's
Replies
18
Views
802
Dave Westlund
D
7
New Holland LX 565 skid steer that doesn't seems to have governor response after overhaul
Replies
0
Views
79
7000Eric
7
S
2-85 engine swap from 750 combine
Replies
3
Views
279
MikeinKy
M
H
1010/2010 engine swap
Replies
5
Views
501
BarnyardEngineering
BarnyardEngineering
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top