Anonymous-0
Well-known Member
Just removed the header lift cylinders on the L3 to rebuild them and I am not sure how to disassemble them. Can anyoneone advise how to get them apart? Thanks
- Thread starter Anonymous-0
- Start date
Skyhighballoon(MO)
Member
- Location
- Pilot Grove, MO
Not sure if they applies to L3"s but Allis did have cylinder designs with internal snap rings. Remove the hydraulic hoses and look in hose port. Might be a snap ring you move from one slot to another to be able to pull the rod out. Mike
Scott in Illinois
Member
Thanks Mike, you were absoutely right. I have them all apart and waiting for new seals.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy