case 1060/1160 parts

gillet598 · Dec 24, 2012

i am refurbing a case 1160 i bought last fall and am wondering if anyone knows where to get feeder house chain and the floor. called messicks and they could not cross the chain not sure why any help on where you get your parts would be great.

Straw Boss · Dec 24, 2012

Ask on the Case Forum. Lots of knowledgable Case combine guys over there who love to help. Merry Christmas!

DeltaRed · Dec 24, 2012

I'll bet it's CA 550 chain.Manchester Manufactureing
(Manchester,OK.)will be able to get your chain(they
probably have it in stock).Wait till 'Casenutty
1660' sees this....I KNOW he will have the answer
you need!

Case Nutty 1660 · Dec 25, 2012

Delta I believe has the right number for the feeder chain, as to the floor tin I think you will have a very hard time finding any NOS or reproduction stock, I will assume you are working on a grain hdr as you asked for floor tin, keep this in mind 1000/1010 hdrs will all work and there are a lot of these out there, only differance is the 1000 hdrs have a different carrier yoke size so these will have to be changed out if you intend to use a 1000 hdr, also the 1160 uses a #80 drive chain unlike the others that use #60 but you can change the drive sproket out no problem I do have NOS floor tin that I could get you measurements from but sorry my sets are not for sale hope this helps we all would like some pics of your purchase/progress if you don't mind, I can check out the chain # also but I know that is correct for my 1660 and I do think the 1000/1160 had the same side chains cnt

casecollectorsc · Dec 25, 2012

I replace the floor tin with 20ga. stainless. Only have to do it once that way. 20ga. stainless is as strong as the 18ga original but easier to work with.

Case Nutty 1660 · Dec 25, 2012

thats a very good point!! thanks cnt

gillet598 · Dec 25, 2012

Thanks all. Rebuilding header and the floor and chain in the combine itself diagram 142 in 1060 book any measurements would be great

gillet598 · Jan 3, 2013

began removing old floor in combine. turning into quite the job. it has been patched so many times i am having to take the patches off in order to take the orgional floor off. btw the orginal is about 1/16th inch thick in some spots. i think it has seen a few acres. case nutty any chance i could get those measurements? thanks Dan

case 1060/1160 parts

gillet598

Member

Straw Boss

Well-known Member

DeltaRed

Well-known Member

Case Nutty 1660

Well-known Member

casecollectorsc

Well-known Member

Case Nutty 1660

Well-known Member

gillet598

Member

gillet598

Member

Similar threads