Author	[Modern View]
tjiniowa 10-24-2012 09:57:51 63.152.60.77 Report to Moderator	You do know that some functions use more than one solenoid. It is in your operators manual which ones should have power for these functions. Sounds like the one for the return is not working right, it is a one way system for the reel lift, but needs to activate another for oil to return through the valve. Double check that first, and then go from there [Reply]   [No Email]
Bob Bancroft 10-25-2012 16:24:36 97.73.64.146 Report to Moderator	Re: 1460 REEL LIFT in reply to tjiniowa, 10-24-2012 09:57:51   This makes two of you with obvious experience saying basically the same thing. So I just went all through my manual (1991 1660) and I find no such information. One thing I liked very much that AC did was put complete and individual circuit wiring diagrams in their combine books. [Reply]  [No Email]
Jon Hagen 10-26-2012 11:54:26 69.26.17.61 Report to Moderator	Re: 1460 REEL LIFT in reply to Bob Bancroft, 10-25-2012 16:24:36   The reel circuit uses 1 solenoid to lower the reel, but 2 to raise it. One solenoid opens the reel passage, another closes the pump return flow passage through the valve stack. When you lower the reel, the reel solenoid only opens , dumping fluid into the open return flow passage and gravity lowers the reel. To raise the reel the reel solenoid opens and the return passage solenoid closes, trapping pump pressure in the return passage. Thus high pressure fluid is pushed into the reel passage which extends the cylinders. When you release the reel switch from the "up" position, the reel solenoid closes, locking the reel in position, and the return port opens allowing all pump pressure / flow to return to the hyd tank. [Reply]  [No Email]
tjiniowa 10-26-2012 06:36:09 63.152.60.77 Report to Moderator	Re: 1460 REEL LIFT in reply to Bob Bancroft, 10-25-2012 16:24:36   My 1460 manual has it in, also has individual wiring diagrams for each circuit in the back of the book. [Reply]  [No Email]
Bob Bancroft 10-26-2012 10:23:30 97.73.64.153 Report to Moderator	Re: 1460 REEL LIFT in reply to tjiniowa, 10-26-2012 06:36:09   The OPERATOR manual? [Reply]  [No Email]
tjiniowa 10-27-2012 05:39:49 63.152.60.77 Report to Moderator	Re: 1460 REEL LIFT in reply to Bob Bancroft, 10-26-2012 10:23:30   yes, operators manual, I will try to get the info on here later today as I am at work right now on break. [Reply]  [No Email]
Jon Hagen 10-26-2012 15:38:57 69.26.17.61 Report to Moderator	Re: 1460 REEL LIFT in reply to Bob Bancroft, 10-26-2012 10:23:30   I remember the hyd solenoid troubleshoot diagrams, but I think they were in the shop manual ? My shop manual is out on loan right now so I can't check it. [Reply]  [No Email]