I have a 79 Case 444. During the summer, I went to start it and the wire that goes from the ignition switch to the coil went up in smoke and melted.
I got busy and put it in the back of the garage and just used my 8N and riding lawn mower until now when I need the 444 for snow removal. I m planning to figure it out and get it going on Saturday. Can anyone give me an idea of where to start? It s a new coil but it could be Chinese garbage. Just hoping that I could get a good starting point.
This post was edited by Sigma.40 on 12/21/2023 at 05:34 pm.
I got busy and put it in the back of the garage and just used my 8N and riding lawn mower until now when I need the 444 for snow removal. I m planning to figure it out and get it going on Saturday. Can anyone give me an idea of where to start? It s a new coil but it could be Chinese garbage. Just hoping that I could get a good starting point.
This post was edited by Sigma.40 on 12/21/2023 at 05:34 pm.