Gene Davis (Ga.)
Well-known Member
Hi. I am restoring a old Mott push type 21 cut flail mower with a Clinton engine and have a problem with the carburetor body. After cleaning it and as I was reassembling it the threads stripped out of the body where the main nozzle goes, They were very thin and when I tightened it they pulled out before they tightened. Tried building up with J B weld but that did not hold either. Does anybody have a good rebuildable Walboro LMV, LME or LMG carburetor they would sell. I could get by with just the main body and use my inside parts if necessary.
Posted on the stationary engine board also but seems there is very little traffic there.
Gene Davis Tennille, Ga.
Email is: [email protected] xxx ---remove the three x's to send.