Had finally snow enough to use the walk behind Toro snow blower yesterday. I find that when it gets into snow at what
it used to get into the blower has no guts and bogs out. I have to stop to allow it to empty, then reduce speed to
nearly stopped before it will keep up. The shear pins are good. Changed them just this fall to be sure I was ready.
Auger spins good. Second blower also is up to speed. Just it will not handle a pail full of snow without having
trouble. Belts look good. Engine has plenty of power to get through. What's up? What am I missing? These things aren't
that complicated to look at so what could be causing my trouble?
it used to get into the blower has no guts and bogs out. I have to stop to allow it to empty, then reduce speed to
nearly stopped before it will keep up. The shear pins are good. Changed them just this fall to be sure I was ready.
Auger spins good. Second blower also is up to speed. Just it will not handle a pail full of snow without having
trouble. Belts look good. Engine has plenty of power to get through. What's up? What am I missing? These things aren't
that complicated to look at so what could be causing my trouble?