ok so some time back I asked about the wiring on a jd x748 and got a reply that deere didn't advertise their diagrams that much and the systems were complicated..boy were they right...I bet there's 20 ft of wire that doesn't need to be there because of the safety stuff... geez..my question is after all day of tracing and such..i have power from the start position into a plug on the guage pod but its not coming out of another plug in the pod to activate the relay for the fuel shutoff and a third plug on the pod to allow the starter to engage..i have traced all the safety switches and tested and they appear good ...if the guage pod is bad will that cause this problem? or is the pod just an indicator and the wires loop back through the system..the gauges and indicator lights all function as they should..im about ready to rewire this direct and be done with all of the issues..thanks for any help and suggestions