Ford 09JC3336

I inherited a Ford 09JC3336 yard tractor from my father in law.
I am looking for some information on it, specifically what type of oil to put in the hydrostatic transmission.
I Googled the model number and several LGT models came up.
This one does not have LGT on the name plate tag.
I’ve seen pictures of these on this site pulling a moldboard. Mine not being a LGT how much can I pull without burning up the transmission? I’m sure the engine can handle anything the transmission can load up.

That Model No,corresponds to a LGT165(Lawn&Garden Tractor)built from 1/77-12/83.Don't recall off hand if built by Jacobsen or Gilson.LGTs were heavier built than LTs,usally could handle most ground engaging implements.Do you have 3point or sleeve hitch needed to mount plow?If it was "Jake"built theres a Yahoo Group fore Jacobsen built tractors,including Jakes,Ford,Moline,etc where you could no doubt get reliable info you need.

LGT was rated for following,so I expect a plow would'nt be an issue.However I might limit such work to intervals allowing cooldown between and make sure hydro cooling path etc is clear&clean.
---------------
42" Mower deck:
Type: mid-mount Ford
3-blade
Cutting width: 42 inches [106 cm]
Overall width: 52 inches [132 cm]
Cut height: 1.5 to 4.5 inch [3 to 11 cm]

50" Mower deck:
Type: mid-mount Ford
3-blade
Cutting width: 50 inches [127 cm]
Overall width: 60 inches [152 cm]
Cut height: 1.5 to 4.5 inch [3 to 11 cm]

Blade:
Type: front-mount Ford
Width: 48 inches [121 cm]
Lift height: 7 inches [17 cm]
Cut depth: 2 inches [5 cm]

42" Snow blower:
Type: front-mount Ford
single-stage
Clearing width: 42 inches [106 cm]
Overall width: 43.75 inches [111 cm]

42" Snow blower:
Type: front-mount Ford
two-stage
Clearing width: 42 inches [106 cm]
Overall width: 44 inches [111 cm]

Loader:
Loader type: Ford
Height (to pin): 67 inches [170 cm]
Dump clearance: 51 inches [129 cm]
Reach at ground: 20 inches [50 cm]
Lift to full height (at pin): 350 lbs [158 kg]
Bucket width: 38 inches [96 cm]
48 inches [121 cm]

Loader:
Loader type: E.G. & W
Lift to full height (at pin): 700 lbs [317 kg]
Bucket width: 40 inches [101 cm]
54 inches [137 cm]
Raise time to height: 5 s

Backhoe:
Backhoe:Ford 6ft

Shoot,forgot..It WAS Jacobsen built

many thanks,
I will take a closer look at the transmission this weekend.

ray