Re: Craftsman snowblower in reply to Rustyj14, 01-01-2014 16:30:24
I have this older GTV16 and I tried to match a craftsman snow blower to it. The blower has a vertical pulley. Looking for a pulley under tractor to connect belt. The angle pulley I was using underneath was not working, making belt jump off. I attached another pulley next to this angle pulley because it was the only one that was semi lined up with the blower pulley. Hopefully I explained my problem ok, it's kind of a headache to get this to run. Thanks for an help
Re: Craftsman snowblower in reply to Lance Pence, 01-02-2014 16:08:35
Hi Lance, I'm to totally familiar with your tractor model does it have the side shaft engine and if so I don't think that model used an under the belly mule drive I'm thinking it would be like my ST16 where the belt goes from the engine to the SB with a clutching set up between the engine and SB. You may get more information on the Sears section of My Tractor Forum lots of Sears guys very active site.
GB in MN This post was edited by MNGB at 10:58:06 01/03/14.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.