Author	[Modern View]
joe csuti 10-17-2012 02:07:12 151.198.127.179 Report to Moderator	Blower will fit/work on tractor,although in deep/wet snow you may be down in eng hp if eng getting tired. If just a bare tractor & no mower deck you'll need the quick-tac mount for front of tractor or if no quick-tac on tractor check frame rails for 3/8" holes approx 1" back from front of tractor,if rails have holes you can use a long 3/8" rod/threaded rod thru blower arms to hold blower to tractor.The quick-tac was part of the accessory "finishing kit" that included the mule drive to power mower when mower not included with tractor when new,many wh tractors were sold this way by dealers & you bought attachments as accessories along with extra accessory "finishing kit" needed to connect/power attachment. [Reply]   [No Email]
joe csuti 10-17-2012 03:06:02 151.198.127.179 Report to Moderator	As an after thought,you might want to check condition of pto clutch plate lining & clutch bell bearings,if either of above worn blower will slow down/stall in deep/wet snow due to slippage as blower load 2-3x mower deck load on pto,you might also want to also consider making a 5"x10" L bracket out of steel/aluminum & bolting to blower arm to cover blower pulley/belt as wet snow tends to belch/puke out of discharge & drop on pully/belt causeing additional slippage when blowing snow to the right.   [Reply]  [No Email]