Electronic ignition for old briggs

S/C BOB

Member
I have an older horizontal briggs and I d like to change from the points to electronic. Can someone tell me what all is involved in doing this or even if I can..Thanks
 
Without knowing mod# of eng,both the briggs magnetron conversion units & aftermarket conversions(megafire,etc)may/may not work on eng,briggs admits on some mod eng the magnetron conversion won't work due to reverse polarity of flywheel magnets or multi magnets on flywheel,check with local mower shop to see if they have info on which mod eng conversion won't work on.

The after market units also have the same magnet problem,but if reverse polarity on magnets you can rev connections on module to overcome this problem,if flywheel has multi magnets module may not work,it's something you'll have to take a chance on.

Goto link below & type 31-8786 in search & read about module,I've used these modules on several 3-5hp eng with recoil start with good results.
module
 
Also note,conversion units use orig point style coil,if coil weak,going bad or breaking down from heat then these units may not work or cure a coil problem.
 
Get the model number of your engine and the spec number and check with your local B&S dealer if a magnatron armature can be used on your engine. Hal
 
I have a 1969 2hp horizontal shaft B&S engine and took an electronic coil off a newer briggs with the same diameter flywheel and it works great on my old B&S.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top