I'm working on afarmer friend's 3000, and the distributor cap that was on it doesn't seem to fit. It's a little bigger diameter at the bottom than the distributor housing, and the square alignment peg doesn't seem to match the notch in the distributor body.
Yet this is a 3 cylinder cap. I'm just wondering -- was there some variation in distributors used for different years for the 3000?
I can see where somebody has in the past made a scratch mark on the outside of the cap, I guess to align it with the notch -- but the cap can be rotated even when snapped into place with the retainers.
Anybody got a clue what is going on here?
Thanks for your help
Yet this is a 3 cylinder cap. I'm just wondering -- was there some variation in distributors used for different years for the 3000?
I can see where somebody has in the past made a scratch mark on the outside of the cap, I guess to align it with the notch -- but the cap can be rotated even when snapped into place with the retainers.
Anybody got a clue what is going on here?
Thanks for your help