711 Ford Loader Row Crop Front Bracket

Colin King

Well-known Member
I'm fabricating a mock-up of the front bracket for the 711 loader I plan to put on my 961. In photos that Kirk posted in 2015, it looks like the mounting flange bends. Does it bend towards the hip bracket? By how much?

Thank you, Kirk, for the extensive and very helpful photos and measurements you posted back in 2015!

Colin, MN
 
I'm not sure I remember the post but can dig one out and check. I might have an extra one for a row crop for a long box. it would save you for fabricating one. if you have an interest my email is open.
 
I think he's talking the front hanger bracket.
v6700.jpg
 
Colin, Is this the bend you were talking about? If so, SG is correct, it's slight! I never even noticed it on mine.
20898.jpg
 
Thanks, Tom. Yes, where the loader mates to the bracket. Soundguy sent me a couple of photos. Looks like it may bend about 1/2".

Thanks,
Colin
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top