Just replaced my radiator and hoses on 53 Jubilee. Tractor ran well prior to this repair and started right up. No leaks but now the tach is not working like it did. Did not disturb the tach or drive. When I started up the rpms were reading low but gradually went up to about 1500. When I idled down before shut off it didn't move and after cutting engine it stayed at 1500 rpms. Tach was replaced just before I bought it about 3 years ago. Tach drive looks good (I haven't replaced my hood yet till I was sure of no leaks). Any thoughts or suggestions? Thanks, Steve
- Thread starter ncengr
- Start date
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy