65+ 4000 fuel filter

Nickmicco · May 8, 2018

I have bin looking for the glass bowl that goes on the bottom of the fuel filter in the dual filter set up on the 3 cylinder and all i can find is the whole assembly and i dont really want to buy the whole thing if i dont have to if someone could point me in the right direction it would be greatly appreciated

IanC · May 8, 2018

There are basically only four glass bowls for all the CAV filters single or dual. Curved bottom with small (about 3/8") and large (between a nickel and a quarter) holes, and flat bottom with parallel sides and the same hole differences. You should need the curved bottom with the small hole. TISCO (now SMA) used to keep that one under an IH number 314478R1. Take what is left of your old one to compare. I checked this site and couldn't find a cross. The URL for SMA is TISCO, but maybe call this site first to support it.

Ultradog MN · May 8, 2018

I'm thinking you have a gasser and the part
you need is like the one in the photo?
I don't know of anywhere to buy just the
glass part. You are still lucky even if you
have to buy the whole thing.
Up untill recently that filter was no longer
available - anywhere - and they were
getting big bucks for a used one on ebay or
guys had to make do. We made a couple of the
bowls out of aluminum on a lathe that worked
fine.
Now I hear they're available again so I
would bite the bullet and buy one if you
need it.
PS,
Welcome to the board.

Nickmicco · May 8, 2018

(quoted from post at 15:25:08 05/08/18) I'm thinking you have a gasser and the part
you need is like the one in the photo?
I don't know of anywhere to buy just the
glass part. You are still lucky even if you
have to buy the whole thing.
Up untill recently that filter was no longer
available - anywhere - and they were
getting big bucks for a used one on ebay or
guys had to make do. We made a couple of the
bowls out of aluminum on a lathe that worked
fine.
Now I hear they're available again so I
would bite the bullet and buy one if you
need it.
PS,
Welcome to the board.

No what i needed is whats pictured below i finally found it thanks to IanC i dont even see anything that looks like that on mine... Am i missing somethin or is it a different setup? Sorry i dont know much about diesel engines or tractors so im tryin to learn as i go with this thing

Sean in PA · May 9, 2018

i dont even see anything that looks like that on mine...

The part that Ultradog posted the picture of is the sediment bowl for a gas engine tractor, not a diesel. Since you didn't specify which yours was in your original post (but you did give a hint by mentioning the dual filter setup) he was offering info on that one.

Ultradog MN · May 9, 2018

Thanks.
And the one I showed is a dual filter -
sediment bowl + the center post is a filter.

65+ 4000 fuel filter

Nickmicco

New User

IanC

Well-known Member

Ultradog MN

Well-known Member

Nickmicco

New User

Sean in PA

Well-known Member

Ultradog MN

Well-known Member

Similar threads