(800) 853-2651
SHOP NOW

960 pinion bearing again

K

Keith Molden

Well-known Member
OK guys, here's the deal. I got the bearing for the 960 pinion from my dealer and it was not the bearing that will fit on the pinion shaft that I have, so I went to Bearings incorporated and got the bearing that fits the shaft and the outer race. bearing # Timpken HM804843. I'm still wondering just what pinion shaft I have in this tractor The numbers on the end of the shaft are 868 and 25PA and about middle of the shaft length is Ford NCB4610A. The front bearing # is HM803149. I'd sure like to know what pinion I have in this thing for future reference, anybody got any books that would possibly tell?? Keith
 
There is a race that goes on pinion cnh # BB-4626-D. The pinion is not hard enough to run roller bearing on. The roller bearing is BB-4625-B from cnh.
 
I'd sure like to find out what pinion I have in this thing. Dealer only shows 1 for it (which it isn't the 1 I have). Keith
 
You must log in or register to reply here.

Similar threads

N
Pinion bearing moving
Replies
5
Views
606
NMNeil
N
H
Steering wheel shaft bearing replacement
Replies
6
Views
470
Hunter1897
H
P
Gehl FC 72B flail chopper bearing replacement
Replies
10
Views
333
BarnyardEngineering
BarnyardEngineering
M
Ford 3000 rear drive shaft movement
Replies
7
Views
470
markwolumla
M
D
Tw-5 PTO driven gear and needle bearing
2
Replies
22
Views
1K
Daniel in PA
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top