Hi guys
I have my lift cover off hydraulic pump is on the way and I'm adjusting my linkages. My manual says page 41 3 position the upper edge of the lift control lever 3.25 inches below the top stop on the quadrant retainer. I am not understanding this I took my micrometer dialed into 3.25 I took the micrometer and position it on the upper part of the lift lever the other end of the micrometer touching the adjustable stop that is on top. How accurate is that? I've checked it three times and every time I get a different reading on the plunger it is supposed to be . 200 in I'm getting .165 .150 .170 could someone tell me how to accurately get the lift arm in the right location and am I doing it right?
I have my lift cover off hydraulic pump is on the way and I'm adjusting my linkages. My manual says page 41 3 position the upper edge of the lift control lever 3.25 inches below the top stop on the quadrant retainer. I am not understanding this I took my micrometer dialed into 3.25 I took the micrometer and position it on the upper part of the lift lever the other end of the micrometer touching the adjustable stop that is on top. How accurate is that? I've checked it three times and every time I get a different reading on the plunger it is supposed to be . 200 in I'm getting .165 .150 .170 could someone tell me how to accurately get the lift arm in the right location and am I doing it right?