I continue to work the old ford trying to fix the hydraulics. So far with the help of this forum i have removed the lid, replaced all the O rings, Piston, cam follower pin(that sucker was really worn).
I wanted to see if anyone could tell me what that alternate method is for adjusting the position control, as I don't have the NCA502 gauge or the NCA503 gauge? I have read there is an alternative method in the FO20 manual, but I do not have the FO-20 manual only the Ford shop manual, and am at my wit's end with this.
I would hate to put this lid back on and the adjustments be out of wack with the tear down I did.
If not may take to new holland dealer in the morning to pay them to adjust it so I can get this tractor back running.
I wanted to see if anyone could tell me what that alternate method is for adjusting the position control, as I don't have the NCA502 gauge or the NCA503 gauge? I have read there is an alternative method in the FO20 manual, but I do not have the FO-20 manual only the Ford shop manual, and am at my wit's end with this.
I would hate to put this lid back on and the adjustments be out of wack with the tear down I did.
If not may take to new holland dealer in the morning to pay them to adjust it so I can get this tractor back running.