100 series hyd filt spec

WayneIA · Feb 3, 2018

Center of the filter mount to the transmission center housing is 11 1/2 inches, Top of the center housing to the center of the filter mount is 2 1/2 inches. If memory serves my right I am thinking the curved pipe from tractor hydraulic return to sump line to filter head shouldn't leave much choice but this measurement.
Greg, hope this helps. Didn't get an email ,not sure why

Greg NE · Feb 3, 2018

Thanks a lot!! Just to make sure, your measurements are from the gasket surfaces correct? Transmission joint and lift cover surfaces. Greg NE

Greg NE · Feb 3, 2018

PS, I must have messed up the email but I thought I did it correctly. Greg NE

WayneIA · Feb 3, 2018

Transmission to center flat surface and lift chest to center housing surface. The tractor is intact except I took the filter off. Where in Nebraska are you. I stole my bride from your state 61 years ago. Waco! York county. email should be open again. Probably could get one of the kids to take pictures if necessary.

Royse · Feb 3, 2018

Thank you Wayne!

Greg NE · Feb 3, 2018

Tried another email, hopefully it worked this time!

100 series hyd filt spec

WayneIA

Well-known Member

Greg NE

Member

Greg NE

Member

WayneIA

Well-known Member

Royse

Well-known Member

Greg NE

Member

Similar threads