(800) 853-2651
SHOP NOW

631 Three Point not lifting high enough

H

Herlod

New User
Good Morning.

The lift arms on my 3 point seem to operate as designed with the exception of lift height.
Both arms only lift so high. Not high enough to move implements. And not near as high as my 8n arms lift.
They seem to handle the weight of whatever I attach. Just not high enough.
Any thoughts on this are much appreciated.
 

Is your draft control lever in position mode?

Otherwise suspect cam follower pin wear and internal adjustment issues.
 
You can open you top cover and make the adjustments Or for a quick fix you could remove your draft spring and add a 5/8 washer with a notch to the triangle plate as seen in photo. This raised mine from 17" max to over 24"

Kirk
B8MKiAs.jpg
 
Thanks. Forgot all about Draft Control. The sticker on her must be wrong, or it's the wrong lever. the sticker shows the lever at 12 o clock, and 3
o clock. The lever has a stop on it, that only allows it at 3 o clock and 6 o clock.
So it 3 o clock it is as far counter clock wise as it will go. The lever was in this position when I tried it. I will try today with it fully
clockwise.

Thanks again for the tips!
 
Sweet! Will check this out. Thanks!
Pics are priceless when assembling/disassembling.
They can turned a 2 hour job into an hour job.
 
Just recalled, I believe there is wear, as I moved the lever beyond the max position as dictated by the limiting
bracket, and the arms came up a couple of inches more.
 
Okay. So testing out Draft Control, When the Lever is at maximum counter clockwise, the arms respond and lift to @23 inches with out a load.
When the lever is moved to it's maximum clockwise position, the arms begin to drop.
Will check with a load soon. (next couple of days).
 
You must log in or register to reply here.

Similar threads

C
58 861 3 point doesn't seem to lift high enough.
Replies
3
Views
313
Crashfarmer
C
S
860 3 PTH not lifting high enough
Replies
6
Views
375
saskboy1950
S
C
3 point max height not high enough
Replies
8
Views
531
Hobo,NC
Hobo,NC
P
Three point linkage arms raising and lowering w/o lever
Replies
1
Views
319
alltron
A
B
want to add 3 point backhoe to Ford 4500
Replies
4
Views
437
paul
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top