(800) 853-2651
SHOP NOW

1956 Ford 620

R

ras440

New User
Have rebuilt the steering box and have the sector gears timed ok, but am having trouble meshing the (bearing) worm drive/shaft into the sector gears. I have found nothing on u tube to show this installation. When finished, should I have the 2 1/2 steering wheel turns as noted on the 8N's or is the 600 series different ? Thanks for any help.
 
(quoted from post at 07:43:43 03/29/17) Let me try this again...I have a ford 620 and have rebuilt the steering box and have the sector gears timed ok with the side covers bolted up. I'm having trouble getting the right placement for the steering shaft and nut assembly back into the box to match up with the sector gears properly. What am I doing wrong ? I have the wheels straight ahead with the sector arms straight down. I thought I had it, but the left arm went back farther than the right arm and I'm getting less that one full rotation on the steering wheel going left and right. I'ts a 620 with a front end loader.
Click to expand...
 
(quoted from post at 20:34:14 03/29/17)
(quoted from post at 07:43:43 03/29/17) Let me try this again...I have a ford 620 and have rebuilt the steering box and have the sector gears timed ok with the side covers bolted up. I'm having trouble getting the right placement for the steering shaft and nut assembly back into the box to match up with the sector gears properly. What am I doing wrong ? I have the wheels straight ahead with the sector arms straight down. I thought I had it, but the left arm went back farther than the right arm and I'm getting less that one full rotation on the steering wheel going left and right. I'ts a 620 with a front end loader.
Click to expand...

OK.... I found the answer on the next page. An excellent diagram. Nevermind ! :roll:
Thanks for this blog !
Click to expand...
 
You must log in or register to reply here.

Similar threads

E
Ford 3000 power steering New fuel pump won't prime
Replies
3
Views
194
Sean in PA
S
M
600 manual steering column and gearbox rebuild
Replies
1
Views
354
jaspruden
J
J
NAA Steering box
Replies
0
Views
357
jim warehime
J
H
ford 2000 steering shaft
Replies
4
Views
2K
herve59268
H
Hemmjo
Steering Sector Bushing Puller, (or pusher)
Replies
0
Views
152
Hemmjo
Hemmjo
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top