Sixty7camaro
Member
Replaced the relief valve in my 641 Workmaster and was ready to bolt up the cover when I noticed the locating pin in the cover has a
groove for an o-ring? Didn't have one when I pulled it off and didn't find one in the sump. Looking at the parts blow-up I do not see a
pin in the cover as illustrated. Anyone have experience with this? I see an o-ring listed, .674 i.d X .103 thick but I think that is for
the valve itself. Help appreciated!
groove for an o-ring? Didn't have one when I pulled it off and didn't find one in the sump. Looking at the parts blow-up I do not see a
pin in the cover as illustrated. Anyone have experience with this? I see an o-ring listed, .674 i.d X .103 thick but I think that is for
the valve itself. Help appreciated!