3000 double clutch setting

Can anyone tell me where the standout measurement dimension given in this picture came from. I'm at 1.800 and this is before the setscrew adjustment at .054 being made. I've just not seen that 2.110 being given anywhere. I have the IT and the complete older Ford service download.
a152209.jpg
 
I can't help you on the clutch.
But I will suggest you rethink your method of holding that engine up.
A hydraulic jack??
Yikes!
Gives me the creeps even from here.
 
That's NOT the tractor I'm working on. I pulled this picture right out of a YT post on here from June of 2013.

Scared me too! I think I've answered my own question in different way. A YouTube video was showing a page straight out of an IT manual with those measurements. The one I have ( FO-23 ) from 1967 only shows special tooling to set the finger height.

Thanks for the reply, and the safety tip. I use these stands I made last year.
a152212.jpg
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top