IRONMAN (AL)
Member
I have a 640 that starts to run rough when you are working it,I thought it was the points but i cleaned them and still the same. I went
to clean them again and noticed some play in the dizzy shaft, could this be my problem. Looking at the manual the rebuild is pretty
streight forward rebuild other than reaming the bushing to fit.Is there a trick to getting this right,I have a 1/2 ream but that's to big
according to the manual. Do I need to get the hole kit or just the bushing. THANKS FOR THE HELP
to clean them again and noticed some play in the dizzy shaft, could this be my problem. Looking at the manual the rebuild is pretty
streight forward rebuild other than reaming the bushing to fit.Is there a trick to getting this right,I have a 1/2 ream but that's to big
according to the manual. Do I need to get the hole kit or just the bushing. THANKS FOR THE HELP