mooseracing
Member
I just need a check of sanity, I want to replace the input seals while I have the engine out. The fork looks like just a large pin pinning it to the shaft, not a bolt like the diagrams on NH.
It's taken alot just to move it maybe a 1/4". The punch is almost bouncing as much as when a bearing is driven home, not to mention the mark on my face now.
It should just drive out right?
It's taken alot just to move it maybe a 1/4". The punch is almost bouncing as much as when a bearing is driven home, not to mention the mark on my face now.
It should just drive out right?