Hi guys,
I need to id my tractor so that I can order parts for blown hydraulic hose. I keep finding conflicting information.
Engraved codes behind starter:
KD211F
8H16B
C582444
Raised code on right side of tractor on plates, ie. engine block, plates are screwed onto side.
8D17 (not that legible)
D5NN6015F
Raised codes on bottom side of tractor, seen by laying on back under tractor:
C9NN 6676C
26 F 8
Raised codes on left side of tractor under seat:
N W 05 04 78
D7NN4024-A
LH 1 1 4
Printed in black letters on loader arm: Ford 420
Engraved codes in aluminum looking plate on backhoe controls facing the operator's seat:
?? (series) This is really hard to read, maybe a J, maybe it was never stamped?
19-747 (component)
CB T3549 (serial)
On other side of backhoe controls, facing the arm itself, there is 504 printed in black letters.
Any help or direction would be appreciated.
At this point I'm just trying to get 2 hydraulic hoses that go into the loader control box. But I did have some foamy stuff come out of the small hydraulic arm on the loader bucket that opens the bucket lip a week or 2 ago. So I might need to clean filters and replace the hydraulic fluid itself.
Thanks,
- Ian
I need to id my tractor so that I can order parts for blown hydraulic hose. I keep finding conflicting information.
Engraved codes behind starter:
KD211F
8H16B
C582444
Raised code on right side of tractor on plates, ie. engine block, plates are screwed onto side.
8D17 (not that legible)
D5NN6015F
Raised codes on bottom side of tractor, seen by laying on back under tractor:
C9NN 6676C
26 F 8
Raised codes on left side of tractor under seat:
N W 05 04 78
D7NN4024-A
LH 1 1 4
Printed in black letters on loader arm: Ford 420
Engraved codes in aluminum looking plate on backhoe controls facing the operator's seat:
?? (series) This is really hard to read, maybe a J, maybe it was never stamped?
19-747 (component)
CB T3549 (serial)
On other side of backhoe controls, facing the arm itself, there is 504 printed in black letters.
Any help or direction would be appreciated.
At this point I'm just trying to get 2 hydraulic hoses that go into the loader control box. But I did have some foamy stuff come out of the small hydraulic arm on the loader bucket that opens the bucket lip a week or 2 ago. So I might need to clean filters and replace the hydraulic fluid itself.
Thanks,
- Ian